2022 Topcon Construction GNSS & Network Solutions PN-A5

Information

2022 Topcon Construction GNSS & Network Solutions PN-A5

Pin-based, semi-hemispherical ground plane GNSS antenna

The PN-A5 antenna combines our TA-5 full-spectrum GNSS antenna element with an innovative convex impedance ground plane. The TA-5 antenna element utilizes an array of vertical dipoles to provide highly sensitive and stable full wave signal tracking for all existing and planned GNSS signals. Our new convex impedance ground plane provides improved multipath mitigation while providing minimum signal loss for satellites tracked to the horizon.

Features may include:
  • High-end geodetic antenna
  • Topcon TA-5 vertical convex dipole antenna element for full-spectrum GNSS signal tracking
  • Unique semi-hemispherical convex impedance ground plane
  • Environmentally robust and sealed
  • Minimized phase center offset variations in vertical within GNSS frequency band
  • Improved tracking for low-elevation satellites for signal tracking from the local horizon to zenith

Photos

Highlights

  • Des Moines, Iowa
  • 2022
  • Topcon Construction
  • GNSS & Network Solutions PN-A5
  • Available
  • 262 mm

    • Specifications

    • 2022
    • Topcon Construction
    • GNSS & Network Solutions
    • PN-A5
    • Construction
    • Input Voltage Range: +3 to +12 VDC | Power Consumption: 100 mA
    • Operating Frequency Range: Lower: 1230 MHz±70 MHz / Higher: 1565 MHz±50 MHz | Gain at Zenith (90º): Lower: +6 dB (typical) / Upper: +4.7 dB (typical) | Gain Roll-Off (from Zenith to Horizon): Lower: -12 dB (typical) / Upper: -10 dB (typical) | LNA Gain: 43 dB (typical) | VSWR: 1.5 : 1
    • 50°C to +70°C | Storage Temperature: -55°C to +85°C
    • Noise Figure: 1.0 dB
    • Antenna: D: 15” (380 mm) H: 10.3” (262 mm) | Dome: D: 15” (380 mm) H: 11.5” (292 mm) | SCIGN dome: D: 16.3” (415 mm) H: 11.3” (287 mm)
    • 262 mm
    • 6.7 kg
    • Humidity: 95%, Method 507.5 | Vibration Rating: Method 514.6, Broad band noise (random vibration), Category 4, table 514.6C-IV) | Shock Rating: Method 516.6. Procedure I - Functional Shock, Table 516.6-I, Fig. 516.6-8, accelerative forces up to 40g. | Dust/Water Protection: IEC 60529 IP6X / IEC 60529 IPX7 | Drop Test: IEC 60529 IP6X. Repeated drops from the height of 1 m on concrete surface. All sides – top, bottom | Connector: N-type

    Disclaimer

    Advertised pricing excludes applicable taxes title and licensing, dealer set up, destination, reconditioning and are subject to change without notice. Pricing may exclude any added parts, accessories or installation unless otherwise noted. Sale prices include all applicable offers. Not all options listed available on pre-owned models. Pricing subject to change without notice. Contact dealer for details.