2022 Topcon Construction GNSS & Network Solutions CR-G5

Information

2022 Topcon Construction GNSS & Network Solutions CR-G5

High-accuracy GNSS choke ring antenna designed for all CORS environments

If you’re establishing a new CORS network or upgrading an existing service, the CR-G5 is the perfect antenna for all high-accuracy 24/7 GNSS signal reception needs.

Features may include:
  • High-end geodetic antenna
  • TA-5 vertical convex dipole antenna element for full-spectrum GNSS signal tracking
  • Topcon-designed choke ring ground plane
  • Environmentally robust and sealed
  • Improved phase-center stability in vertical over expanded GNSS frequency band

Photos

Highlights

  • Des Moines, Iowa
  • 2022
  • Topcon Construction
  • GNSS & Network Solutions CR-G5
  • Available

    • Specifications

    • 2022
    • Topcon Construction
    • GNSS & Network Solutions
    • CR-G5
    • Construction
    • Input Voltage:3 to 12 VDCVDC | Power Consumption: 100 mA (typical)
    • Operating Frequency Range| Lower Band: 1230±70 MHz (L5, E5B, E3, L2, G2, E4, E6) / Upper Band: 1565±50 MHz (E2, L1, E1, G1, OmniStar, SBAS, CDGPS)
    • -50°C to 70°C | Temperature Storage: -55°C to 85°C
    • Out-of-Band Rejection Lower: -60 dBc / Upper: -40 dBc / f < 1000 MHz: -60 dBc f > 1750 MHz: -60 dBc | LNA Gain: 43 dB | Gain at Zenith (90º): Lower band: +7.5 dB / Upper band: +5 dB | Gain Roll-Off (from Zenith to Horizon): Lower band: -16.5 dB / Upper band: -13 dB | Noise Figure: 1.0 dB
    • Antenna without anti-snow Dome: 380 mm (D) x 155.5 mm (H) | Anti-snow Dome: 380 mm (D) x 292 mm (H) | SCIGN dome: 415 mm (D) x 287 mm (H)
    • Antenna: 4.9 kg | Dome: 1.1 kg | Antenna & Dome: 6 kg
    • Dust/Water Protection: IP67 IEC | Vibration Rating: Method 514.6, Broad band noise (random vibration), along each of 3 axes, Category 4, table 514.6C-IV | VSWR1.5 : 1 | Differential Propagation Delay (typical): Lower band: 3 ns (maximum) Upper band: 3 ns (maximum) | Nominal Impedance: 50 Ohm | Enclosure: MIL-STD-810G | Humidity: 95% | Shock Rating: Method 516.6, along each of 3 axes. Procedure I - Functional Shock, Table 516.6-I, Fig. 516.6-8, accelerative forces up to 40g | Salt Fog: 5% | Drop Test: Repeated drops from the height of 1 m on concrete surface. All sides – top, bottom and border (with dome) | Connector Type: N-type

    Disclaimer

    Advertised pricing excludes applicable taxes title and licensing, dealer set up, destination, reconditioning and are subject to change without notice. Pricing may exclude any added parts, accessories or installation unless otherwise noted. Sale prices include all applicable offers. Not all options listed available on pre-owned models. Pricing subject to change without notice. Contact dealer for details.